CGS Motorsports is a manafacture of Cat-Back Exhaust Systems & Air Intake Systems for the 2007 Dodge Nitro. CGS also built a 2007 Dodge Nitro for Daimler Chrysler Corp. for the 2006 SEMA Show in Vegas. At the show we were presented with the Daimler Chrysler Design Excellent Award for the Dodge Nitro. Come and check out our site: www.cgsmotorsports.com We have just released the Nitro products on our site. www.cgsexhaust.comwww.cgsintakes.com
Last edited by CGS Motorsports : 01-08-2007 at 03:31 PM.
Does the intake that your company is going to offer affect the MAF sensor at all. I imagine that you would have to leave the sensor in place and make the tubing after the sensor. Is there going to be any sort of heat shield that will protect the cone filter from some of the engine heat. I can't wait to see it and when is it coming. The suspense is killing me. Either the intake or go with a JET Performance chip.
On a random note isn't the nitro engine the same engine as the Jeep Liberty's 3.7L? If so would it be possible take a Liberty intake and apply it to the Nitro application?
Does the intake that your company is going to offer affect the MAF sensor at all. I imagine that you would have to leave the sensor in place and make the tubing after the sensor. Is there going to be any sort of heat shield that will protect the cone filter from some of the engine heat. I can't wait to see it and when is it coming. The suspense is killing me. Either the intake or go with a JET Performance chip.
On a random note isn't the nitro engine the same engine as the Jeep Liberty's 3.7L? If so would it be possible take a Liberty intake and apply it to the Nitro application?
The intake system we make for the Nitro does not affect the MAF sensor at all. The MAF sensor installs back in to our Air Intake System and works great. On this application it does not have a heat sheild do to the fact the our Nitro intake does not make more power with a heat sheild. Yes, this is the same engine as the Liberty but we don't make an intake for the Liberty and also we make all of our intakes to fit the engine and body of each and every vehicle. www.CGSMotorsports.com , www.CGSIntakes.com , www.CGSExhaust.com
I'm waiting to order my Nitro R/T with MYGIG, so I'm hoping by then you will have a cat-back and intake produced for the 4.0L R/T motor. Do you have any plans to do this?
AutoForums.com is the premier network of enthusiast-owned
enthusiast-operated automotive communities.
We operate more than 100 automotive forums where our users consult peers for shopping information and advice, and share
experiences and opinions as a community.
Re: Cat-Back Exhaust Systems & Air Intake Systems
Linear Mode
