I purchased the DNA Motoring 07-12 Dodge Nitro LED Black Smoked Third Brake Light to install on mt 2007 Nitro R/T.
Pretty simple install.
the 2 (T25) Torx screws
unplug electrical plug
pull off washer hose
remove nozzle-lift-gate washer (Mopar part # 68015003AA) There are snap plastic clips on the top and bottom that needs to be depressed to pop-out. The new replacement custom Third Brake Light Does NOT come with this (expensive) nozzle. I had no issue removing this original nozzle.
Since I ordered the Black Smoked Lamp I did not want the nozzle to remain red so I sprayed it Semi-gloss black. However I then ran into an issue since this nozzle did not want to snap into the new lamp! I don't think I damaged the nozzle removing it and did not look broken or damaged. When I found out the cost of the original red nozzle I see why it was not included with the new custom lamp! It is however available from many sources including E-Bay and Amazon. Just Google the above part number.
I decided instead to just glue the now painted black nozzle by removing the gasket with a plastic glue (plastic to plastic). Worked for me.
re-hook up washer hose
re-hook up electrical plug
check that lamp works
re-install the Torx screws
Good to go and Good Luck on your latest Dodge Nitro modification!
If for some reason you want to replace the original Nitro Light with the same, the Mopar Part No. is: 55157147AF
Nitro Year: 2007 (1 of 91,815 sold in 07)
Nitro Model: R/T 4X4 Stone White
CAT-BACK Exhaust, CAI, Projector Head Lamps
Fully-Equipped w/all factory options