Dodge Nitro Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
hello. was wondering if anyone has done a hub and bearing install on a 2208 nitro and if it is difficult. could use some advice. thanks.
 

·
Super Moderator
Joined
·
24,990 Posts
2008 Dodge Nitro - Part 6 - REPLACING WHEEL HUB DRIVERS FRONT


Jul 5, 2020

In this episode. I go over the diagnosis towards replacing the front wheel hub and bearing. Just a few days ago my wife pulled up and the suv was smoking. It startled me to jump up with the benz laptop and i broke the usb connection for the multiplexer in the back. I drove the suv one day for work and found out that the drivers brake was stucking to the rotors causing everything to heat up. This is the reason behind the smoke. I greased up the brake pads and noticed that the wheel hub and bearing needed replacement
 

·
Super Moderator
Joined
·
24,990 Posts
Wheel Hub Bearing Replacement


04/11/2021

Demonstration on removal and installation of a wheel bearing or wheel hub bearing in a 2007 Dodge Nitro 4x4. This process is similar on many other vehicles with slight variation. Save money by doing it yourself and avoid costly mistakes with these helpful tips and tricks. Bonus Footage at the End includes paramotor animal control at an airport runway and recovery of a couple rockets. Lubricant featured → https://www.cs4000.net/XtremeGreen/me... Torque wrench used → https://amzn.to/3mySBra (now yellow) Impact gun featured → https://amzn.to/3t5tZJ9 Fuel 12V ratchet → https://amzn.to/3d3ENC5
 
1 - 4 of 4 Posts
Top